67 Design Series 55 Rail System

67 Design Series 55 Rail System

Dang, This new Series 55 rail system is nice for the new truck! I’ve always wanted to run their system but never had a vehicle that allowed it. But finally! I do.

So, all in all, I am very stoked on this system it seems pretty damn solid considering that its only 2 nutserts holding it down. And with a phone and GoPro mount its has minimum shake. I will be adding a mic mount at some point for my Midland system.

You can have up to 3 ball mounts so it gives you a lot of options to play around with. I am sure I will go through a couple of versions to get it dialed. Currently, the setup is the universal phone mount, Which works really well and doesn’t have a super tight spring so it’s pretty effortless to put the phone in and out. Second up is the GoPro mount with a nano arm. On my third 1” ball I will be doing a mic mount.

If you have a Tacoma or Jeep 67 Designs has a ton of options for you! So check them out.

The rail bolted into the Ram's dash tray with three ball mounts spaced along it

The rail in use, a camera with a shotgun mic on one ball and a phone on another, below the mirror

The same setup from the driver's seat, phone and camera held clear of the wheel

Close on the bare rail in the tray and the two nutserts holding the whole thing down

0 comments

Leave a comment

Please note, comments need to be approved before they are published.